All kits are gone and will not be restocked.
This kit is meant to be an introduction to CNC Machines, just getting started or learning to DIY CNC. The included motors are small but plenty strong, they can more than handle a smaller end machine for light routing, drilling, etching, ect.
Included:
- 3 Axis CNC Driver Kit with Source Code
- 3x Unipolar stepper motors, 42SH-32KCA, 12 volts at 60ohm per phase, 3.75 degree/step.
Body: 1-11/16" square x 1-5/16" H.
Shaft: 3/16" dia x 7/16"L flatted shaft.
The mounting bolts are 1.25" apart, on square.
Motors have approx. 24" of wires for each connection.
- 6x power resistors, for 12 - 24v
- 6ft Dual Strand wire
Requires at least 12V @ 2A PSU at Minumum. Suggested that a 24V @ 2.5A PSU is used instead, requires proper resistor values(included). A Linear Power Supply should be used, not a switched mode. Please specify the voltage of PSU you will be using when ordering, so the correct resistor values can be included.
View This Image for Motor Hook Up Diagram
A Power Supply can also be purchased by request. Currently Offering Sola SLS-24-036T, 24v 3.6A Linear PSU for $45
If you would like different motors or PSU Contact Us for Pricing
